Belkin Camera: Default IP, Username, Password, Port
Belkin network cameras are known for their simple installation process, but many users still need the default login details when setting up the device or restoring it after a reset. These defaults help you access the camera interface, change security settings, and adjust video parameters. Below you will find the commonly used factory parameters for Belkin models and practical explanations that help you work with them safely and correctly.
Default IP Address
Most Belkin cameras use a private network address that allows the device to be discovered during the first setup. In many cases the default IP is 192.168.2.3, which keeps it consistent with the typical numbering used by Belkin routers on home networks. If this IP does not open the login page, the camera may receive a new address through DHCP. You can check it through your router's connected devices list or use a network scanner to locate the active IP.
Default Username
Belkin cameras often ship with a simple default username to allow the user to reach the initial configuration panel. The most common value is admin. Some older models skip the username field entirely and rely only on a password, but newer or more advanced devices usually require entering admin before accessing settings.
Default Password
The usual factory password for Belkin cameras is also admin. If the password does not work, the model might be set to use a blank password until the first login. Performing a hardware reset on the camera will restore the original password. After successfully signing in, it is important to change this value to prevent unauthorized access, especially if the camera is visible on a network with many users.
Default Port
Belkin cameras typically use port 80, since it is the standard port for HTTP access. Some models allow video streaming or mobile viewing on additional ports such as 8080 or a device specific port set during installation. If the default port has been changed and you no longer remember it, a full reset will return the device to port 80, making it accessible again through the browser.
Connect Belkin cameras to VXG Cloud VMS with GenAI for free
Learn moreFAQs
