Wanscam Camera: Default IP, Username, Password, Port
Wanscam cameras are known for their cost-effective performance and flexibility in both residential and commercial surveillance setups. The brand offers a wide range of IP cameras that support remote viewing, night vision, and motion detection. Setting up a Wanscam camera for the first time or restoring it after a reset often requires knowing the default network credentials. These details allow you to log in, adjust the configuration, and connect the device to your preferred monitoring software or app. Below are the standard default settings and answers to frequent setup questions.
Default IP Address
The default IP address for most Wanscam IP cameras is 192.168.0.178. This address is used to access the camera’s web interface directly from a browser when your computer is on the same local network. If you cannot access the camera using this address, check that your router operates on the same subnet or use the Wanscam IP Camera Tool to automatically locate the camera’s current IP.
Default Username
The standard default username for Wanscam cameras is admin. This account gives you full administrative control over the device, including settings for video resolution, wireless configuration, and firmware updates. After the initial login, it’s best practice to create a new user profile with a unique password to reduce the risk of unauthorized access.
Default Password
Wanscam cameras typically ship with either admin, 123456, or a blank password (no password required). If none of these work, the device may have been pre-configured by a retailer or previous owner, and a reset will return it to factory defaults. Once logged in, always set a new password immediately—leaving the default one in place can expose your network and camera feed to potential intrusions.
Default Port
The default HTTP port for Wanscam cameras is 80, while some models also use port 8899 for media streaming or app connections. You can change these ports in the network settings of the camera to avoid conflicts with other devices or to enhance security. For remote access, configure port forwarding in your router or use Wanscam’s app, which typically detects the camera automatically after login.
Connect Wanscam cameras to VXG Cloud VMS with GenAI for free
Learn moreFAQs
